3D Mach Construction / MOTORBIKE

3D Mach Constructor / MOTORBIKE
Suitаble from the age of 8
Adult supervision is required at all times!

Instructions:
1. Empty out your matches onto a clean, clean surface.
2. Take a match and cut it to the length required to follow the stick instruction bar.
3. Continue to build your model by making the relevant cuts to miter in the joints.
4. Joints should be stuck with the glue provided. Please leave the matches an appropriate length of time to set hard. (approx. 4 hours).
5. Slowly build up the separate sections and bring the motorbike together at the end.
6. The motorbike is made up of matchsticks that have to be cut to a specific length, these are specified as a pre-cut on the instruction tаble.
Lay the acetate sheet of the instruction page and build your matchstick model on top. As you stick the matches together lay them over the technical drawing for a guide.
Overlay the match drawing with the acetate sheet provided and lay down your matches measuring, marking off, and cutting before you glue together.
1. Bike frame
2. Exhaust pipe
3. Bike Frame
4. Exhaust pipe
5. Front Forks
6. Fork Separators
7. Main seat (attaches to both sides of the bike)
8. Petrol tank (attaches to both sides of the bike)
9. Taillights. Mudguard cross pieces. Connect the two sides of the mudguards to create the full guard
10. Guard cover left
11. Guard cover right
12. Handlebars
13. Main light. Build up the layers of the main lamp.
14. Speedometers
15. Attach the speedometers to the top handlebar and attach the main light.
16. Wheel cut 1. Wheel sprockets
17. Wheel cut 2. Wheel sprockets. Tyre tread


NB! (Illustration purposes only) Do not overlay with matches.
18. Attach the two sides of the bike together and attach the